Proper ventilation will prevent moisture from getting trapped in the bathroom, which can lead to mold and mildew growth. Extract moisture by installing a ducted exhaust fan on a timer. Most timers allow you to set the fan for 15 to 60 minutes to remove heat, steam and condensation. Choose a fan according to the cubic feet per minute of air it moves.
Pedestal sinks can saver or waste space depending on the arrangement and storage options of your bathroom. If you want to open up floor space, they’re an excellent choice. However, they don’t offer the storage that vanity cabinets provide. If your bathroom lacks storage but you have your heart set on a pedestal sink, include open shelves or a tile-lined niche behind or adjacent to it. Alternatively, consider using cabinetry 16 or 18 inches deep, instead of the usual 21 inches, to maximize your floor plan.
I acknowledge that The Home Depot is partnering with me to participate in this Delta UPstile Program (the “Program”). As a part of the Program, I am receiving compensation in the form of products and services, for the purpose of promoting The Home Depot. All expressed opinions and experiences are my own words. My post complies with the Word Of Mouth Marketing Association (WOMMA) Ethics Code and applicable Federal Trade Commission guidelines.

The tank is concealed within a 2×6 wall that’s built in front of the existing plumbing wall. It does require some plumbing rerouting because the waste line runs through the wall instead of the basic floor-mounted toilet flange (see Photos 8 – 12). The toilet can be ordered with a wall-mounted access panel/flush button like ours or with the panel mounted on top of a half wall. A ‘chair carrier’ (Photo 11) comes with the toilet. This steel framework contains the toilet and operating mechanisms and is designed to support the weight of the toilet.


If your room is wider than the shower base, fur in the walls as needed to butt against the ends of the shower base (see Photo 14). Our bathroom is 6 ft. wide, so we added a floor-to-ceiling 2×6 wall at the showerhead end and a shorter 2×6 wall at the opposite end. We made that wall only 43 in. above the floor so we could use the top of the wall to hold shampoo and other shower supplies. The shower base usually comes with a special 2-in. drain fitting that you connect to the drain line (Fig. B).
With the rough plumbing complete and the toilet chair carrier in position, finish the electrical and add blocks as needed to support the sink (Photo 15), towel bars, grab bars, etc. Then close up the walls. We recommend cement board for durable tile walls and floors, but other tile backers are available at tile shops. Here are key installation tips:

In a world that’s moving faster than ever, we know you don’t have any time to waste. So don’t let the installation of a new bath or shower interfere with your busy and active lifestyle. At West Shore Home, we’re focused on being fast, easy, and efficient. Our certified full-time installers work relentlessly to finish your new bathroom quickly, minimizing the impact on your home and life. Whether you need a new bathtub, shower, or tub-to-shower conversion, we’re committed to getting the job done right in just one day, and we cover all our work with a lifetime warranty. Just choose your color, tile pattern, and accessory options to customize your bathroom the way you want it, and we’ll make it happen.


There is nothing better than getting into a hot shower at the end of a long day. My husband and I have been wanting to do some remodeling to our master bathroom and I would love to have any one of these designs. They look so functional for their size and I love the shower doors in some of these designs! These have given me some great ideas, thanks for sharing!
Turn off the main water supply to the house, and in a convenient location, cut the hot and cold water supply pipes for the bathroom. Also cut out and remove all the existing water lines and fittings in the bathroom. Finally, cut out and remove the vent section leading to the sink and the main stack 5 in. below the vent tee. Stuff rags into open drain lines to keep sewer gas out of the house.

Last year I bought a house that had the stainless steel micro model installed. The house was surrounded by 80’ tall Maples & Birch. TONS OF LEAVES.Yes, it the micro mesh keeps all leaf and seeds out of the gutter 100%. What the manf and dealers won’t tell you is that you must clean the mesh 2x’s a year to get spring pollen, mold, & fall leaf dust off. Otherwise it will eventually keep EVERYTHING out, including WATER. Major ice problems flowing over the gutters. No it was not the result of ice damming. I removed it all & just deal with the leaves 3x’s each fall.Got ranch home with easy access to the gutters - get the micro mesh. Easier to clean that than clean gunk out of the gutter.hire a young buck to climb a ladder. A whole lot cheaper.
A DIY bathroom remodel is a big project. If you can only work weekends, your bathroom will be out of commission for two months or more. You’ll need all your expertise as an experienced do-it-yourselfer because you’ll have to tackle electrical, plumbing, tiling, drywalling, taping and even exterior siding. In this DIY shower remodel article, we’ll deal mostly with the nuts and bolts of ripping out existing plumbing and replacing it correctly with new, easily installed PVC piping.
Unlike clunky over-the-showerhead organizers, a recessed cubby in a tub or shower surround gives shampoo and soap a permanent home and doesn't take up stall space. Size it to minimize tile cuts, and line the bottom with a leftover piece of stone or solid-surface countertop, not tile, so that you won't have to scrape away scum from grout lines. If you have kids, add an extra cubby around knee height so that they can suds up on their own.
The special-order fixtures, fittings, shower pan, tile and glass block panel can take weeks to get in hand, so do the necessary legwork and ordering well in advance. Before gutting the bathroom, check to make sure that there are shutoffs for all the fixtures or a master shutoff for the entire bathroom. If not, buy ball valve shutoffs sized to fit your pipes. Then turn off the main water supply line where it comes into the house from outside, cut the pipes feeding the bathroom and install the new shutoffs right away (see Photo 7).
×