Choose the main color theme for your bathroom, but it should depend on the existing color of the wall. For example, for white colors, apply the white color on all over the walls and furniture. But to keep the contrast, apply a bit darker color for your flooring. You can do it by having a cheaper tile stamp to get the floral or another exciting pattern.
Follow Fig. B, for the new drain/vent plan. The new shower drain is vented separately into the main stack (Photos 10, 12 and 13). Most bathrooms have the main stack positioned directly behind the toilet. The wall-mounted toilet shown here cannot be positioned directly behind the stack because there’s not room for the necessary elbows. If your stack is more than 12 in. to the side of the existing toilet, you can keep the same location for the wall-hung toilet. But if it’s directly behind it, you’ll need to swap the sink and toilet locations like we did.

Renovating a bathroom is no small undertaking. So before you start tearing up the tiles and picking out the tub, get a little advice from the people who make bathroom makeovers their bread and butter. We polled contractors, designers, and other pros for their top tips and insider tricks for getting every detail right. Follow these DIY bathroom remodeling tips and you're sure to create the bathroom you always wanted.

The job of installing our wall-mounted fixtures was tougher than it had to be, thanks to poor and contradictory one-size-fits-all instructions, metric fittings and duplicate and missing mounting parts. Prevent hard-to-fix future problems by test-fitting the actual fixtures when roughing in framing, plumbing and blocking to make sure everything will work out. Then finish the walls. When test-fitting, simulate finished floor and wall surfaces to get the clearances right.
Don't settle for a wimpy flusher. Maximum Performance testing (MaP) gauges a toilet's ability to get the job done with just one push of the handle. Look for a loo with a MaP score of 500 or higher; this group includes many WaterSense-rated toilets, high-efficiency models that use as little as half of the 1.6-gallon-per-flush legal limit. Go to map-testing.com for more info.
Great tips. At the onset of explaining various causes of a squeak, Tom Silva says it can be alignment, either of the door-to-hinge, or hinge-to-hinge. Hmm, seems to me those two scenarios different than the case in the vid, that being singular hinge with the barrels out of alignment. So, the vid shows a great solution to fixing out of alignment barrels, but what about fixing doors with hinges out of alignment from each other, or hinges out of alighment on the door? How do you make that determinations, and what is the solution? thx
For your remodeled bathroom to operate well, it’s critical to install vent and drain lines of the proper size and slope. Use a 2-in. line to drain the shower and 1-1/2-in. line to drain the sink. The vents for the sink and shower can be 1-1/2-in. pipes, but a toilet should be vented with at least 2-in. material. Make sure that the drain lines drop 1/4 in. for every foot of travel toward the main stack.
The key to a weatherproof, attractive glass block window both inside and out is to encase it in a custom-built wooden frame (Fig. A) with inside dimensions that are 1/2 in. taller and wider than the panel itself. That will give you room to adjust and shim the panel exactly and then inject expanding foam between the frame and the panel to lock it into the opening (Photos 3 and 4).
The wall-hung toilet’s supply line must have a male adapter with a temporary galvanized cap. Check the instructions on the toilet to get the proper location. Routing water supply lines is different in every bathroom, so you’ll have to adapt runs to your situation. But run the plastic drain lines and vents before starting any supply work. It’s much easier to route water supply lines around drain lines than to route drains and vents around supply lines. The same thinking applies to electrical work: Wait until the water supply work is finished before wiring.
Remodeling your bathroom might seem like a complex task, but proper planning can help you get the look and feel you want for your home. Use this guide to learn more about the benefits of remodeling your powder room, guest bathroom or master bathroom space. Typically, bathroom remodels start at $5,000 and can vary based on the size of your room and the products you choose to update.

Turn off the main water supply to the house, and in a convenient location, cut the hot and cold water supply pipes for the bathroom. Also cut out and remove all the existing water lines and fittings in the bathroom. Finally, cut out and remove the vent section leading to the sink and the main stack 5 in. below the vent tee. Stuff rags into open drain lines to keep sewer gas out of the house.

×