With the rough plumbing complete and the toilet chair carrier in position, finish the electrical and add blocks as needed to support the sink (Photo 15), towel bars, grab bars, etc. Then close up the walls. We recommend cement board for durable tile walls and floors, but other tile backers are available at tile shops. Here are key installation tips:
Renovating a bathroom is no small undertaking. So before you start tearing up the tiles and picking out the tub, get a little advice from the people who make bathroom makeovers their bread and butter. We polled contractors, designers, and other pros for their top tips and insider tricks for getting every detail right. Follow these DIY bathroom remodeling tips and you're sure to create the bathroom you always wanted.
Turn off the main water supply to the house, and in a convenient location, cut the hot and cold water supply pipes for the bathroom. Also cut out and remove all the existing water lines and fittings in the bathroom. Finally, cut out and remove the vent section leading to the sink and the main stack 5 in. below the vent tee. Stuff rags into open drain lines to keep sewer gas out of the house.
×